Customer Support>Downloads>Version Download Manager

Version Download Manager
 

Licensed Thermoflow customers may download software from our website.

Quick & Easy Procedure
If you have Version 20 installed, then you may already have the download manager installed.  If so, run it using one of the two methods shown below.

1. Press Start -> All Programs -> Thermoflow -> Version Download Manager -> Launch VersionDownloadManager.exe as shown below.

2. Run the program VersionDownloadManager.exe located in your TFLOW20 folder, C:\TFLOW20\VersionDownloadManager.exe if you installed using all defaults.  You can find and run it using the file explorer as shown below.

Two-step Download Procedure

If you don't have the download manager installed already, then start by downloading it using the steps below.

Note: Thermoflow Version Download Manager must be installed on, and run from, a computer with a functioning Thermoflow HASP key attached.  Any computer that can run Thermoflow software now, or you plan to use to install the software should work fine.

Steps to follow:

1. Click here to download a zipfile containing the Version Download Manager installation program.  Be sure to choose the Save option as shown below.

 

 

 

2. Open the zipfile downloaded in step 1 above, and run the program (setup.exe) it contains. This will install the Version Download Manager program.

 

 

3. At the end of this installation process, click the Finish button with the Launch the program checkbox checked.  That will start the Version Download Manager.

 

 

 

4. The Version Download Manager looks for a Thermoflow HASP key. The following screen is shown if a valid key is found. This should happen in most cases.

 

 

The option buttons are used to select if this computer IS connected, or IS NOT connected to the internet.  In either case click the button on the right-hand side of this window to continue.

 

 

5. In the event a Thermoflow HASP key cannot be found, the following window is displayed.

 

 

The most likely problem is the key is not attached.  In this case, simply attach the key and press the Yes button.

 

The second most likely problem is the HASP device driver is not installed.  In this case, press the No button to start the HASP installer.  Afterwards, rerun the Version Download Manager with the key attached and driver installed.  You will find a link to the Version Download Manager program in a newly created Thermoflow program group under your Windows Start button.